Texalab Logo

Quality Makes Us Strong

Department of Civil Engineering
Reinforced cement concrete RCC DESIGN
Note: Please enable javascript to view the correct answers.
Preperation Over ! Give free Online Examination
Question 1 : For a slab spanning in two directions ,the ratio of span to the depth of slab should not exceed (up to 3.5 m span)
Option-1 :10
Option-2 :20
Option-3 :35
Option-4 :50
Question 2 : A two way slab
Option-1 :may be simply supported on the four edges, with corners not held down and carrying uniformely distributed load.
Option-2 :may be simply supported on the four edges, with corners held down and carrying uniformely distributed load.
Option-3 :may have edges fixed or continuous and carrying uniformly distributed load
Option-4 :all of the above
Question 3 : A slab simply supported on the four edges , with corners not held down and carrying uniformly distributed load, is used in multistoreyed buildings
Option-1 :yes
Option-2 :no
Question 4 : Tthe reinforcement in the short span is placed .......the reinforcement in the long span.
Option-1 :below
Option-2 :above
Question 5 : when the slab is supported on all the four edges and the ratio of long span to short span is small , bending takes place along both the spans . such a slab is known as a
Option-1 :slab spanning in one direction
Option-2 :Slab spanning in two direction
Option-3 : Two - way slab
Option-4 : either (B) OR (C)
Question 6 : The diameter of bars used for distribution reinforcement in slabs, may vary from
Option-1 :2 to 4 mm
Option-2 :4 to 6 mm
Option-3 :6 to 8 mm
Option-4 :8 to 12 mm
Question 7 : In a simply supported slab , the pitch of distribution reinforcement should not be more than ..... the effective depth of slab or 45 cm whichever is smaller.
Option-1 :double
Option-2 :three times
Option-3 :fivetimes
Question 8 : When a slab is continuous over several spans, negative (i.e, hogging) bending moment is induced over the
Option-1 :edn supports
Option-2 :intermediate supports
Option-3 :both (a) and (b)
Option-4 :none of the above
Question 9 : The reinforcement in a continuous slab is provided at the top of the slab portion over the intermediate supports.
Option-1 :right
Option-2 :wrong
Question 10 : The pitch of bars of main reinforcement in solid slab should not exceed ....the effective depth of slab or 30 cm whichever is smaller.
Option-1 : Double
Option-2 : three times
Option-3 : five times
|<   1     2     3     4     5     6     7     8     9     10     11     12     13     14     15     16     17     18     19     20     21     22     23   >|

Visitors : 1886295


Copyright © 2016 . All Rights Reserved.